Home > News > Content

The Reason And Solution Of PU Conveyor Belt Running Deviation

Aug 23, 2017

     Conveyor belt running deviation is one of the most common faults. There are many reasons for running the deviation, the main reason is the low installation accuracy and the daily maintenance of poor maintenance. In the installation process, the head and tail rollers, middle rollers between the same central line, and parallel to ensure that the conveyor belt is not biased or less. In addition, the belt connector should be correct and the perimeter should be the same. In the course of use, if the deviation occurs, the following checks are made to determine the cause and make adjustments.PU Conveyor Belt
     Conveyor belt deviation often check the location and treatment methods are: Check the roller transverse centerline and belt Conveyor Longitudinal center line of the degree of overlap. If the value of the non coincidence is over 3mm, it should be adjusted using the long mounting holes on both sides of the Idler group. The specific method is which side of the conveyor belt is biased, which side of the Idler group moves forward toward the conveying belt, or the other side moves back. Check the deviation value of the two planes of the bearing seat installed on the head and tail rack.PU Conveyor BeltPU Conveyor Belt
     If the deviation of the two planes is greater than 1mm, the two planes should be adjusted in the same plane. The head Drum adjustment method is: if the conveyor belt to the right side of the drum, then the right side of the roller bearing seat should be moved forward or left bearing seat back shift; if the conveyor belt to the left side of the drum, then the left side of the roller bearing seat should be moved forward or the right side of the The adjustment method of the tail roller is just the opposite of the head cylinder. Check the position of the material on the conveyor belt. PU Conveyor Belt
     The material in the conveyor belt cross section is not centered, will cause the conveyer belt to run slants. If the item is on the right side, the belt runs to the left side and vice versa. You should center the item as much as possible when you use it. In order to reduce or avoid the deviation of such conveyor belt can increase the baffle plate, change the direction and position of the material.PU Conveyor Belt
     PU Conveyor Belt Introduction: PU Environment-friendly materials: PU (PU) as a conveyor belt production raw materials, product formulation scientific and reasonable, in line with food hygiene standards can be directly contact with food, color moderate, no taste. and has: oil resistance, corrosion resistance, cold resistance, cutting characteristics. Polyurethane (PU) conveyor belt using a specially treated high-strength synthetic polyurethane fabric as a bearing skeleton, coating layer by polyurethane (PU) resin made. PU Conveyor Belt
     Not only has the ordinary conveyor belt tensile strength high, the curvature is good, light, thin, toughness and so on characteristics, and oil-resistant, non-toxic health, easy to clean. This type of conveyor belt fully complies with the American FDA health standards, wear-resistant, anti-aging, is a durable delivery products.PU Conveyor Belt