Home > News > Content

Bonding Of Conveyor Belt

Sep 08, 2017

       The introduction of conveying materials is an indispensable link in the production of industrial enterprises. In the long run, belts are often torn or broken by external forces. Therefore, the solution to the conveyor belt connection problem is more prominent. The handling of the interface is general, the connection method of the conveyor belt has riveting method, the conveyer belt buckles The connection method, the hot legality and the room temperature bonding method and so on. For the installation of metal detectors of the conveyor belt, the use of riveting or fastener connection method to connect, is obviously not appropriate, the use of thermal legal procedures complex, time-consuming.Conveyor Belt
      Therefore, now most of the use of room temperature bonding method. After the bonding of the conveyor belt in the complex operating conditions, it is easy to appear local fracture and corner rise, and even the phenomenon of overall shedding. To this end, we have conducted a deep exploration, think that the normal temperature bonding belt should pay attention to such as.Conveyor Belt
      In the use of conveyor tape adhesive bonding, especially in the summer when the use of refractory adhesive bonding, often we feel that the surface of the adhesive layer has been dry, but after the joint is very easy to peel off, and bonding surface of the adhesive layer with hand touch and sticky, the formation of "dry before wet" phenomenon, resulting in sticky or sticky. Conveyor Belt
      This is due to the high temperature in summer, the solvent in the adhesive volatile than the autumn and winter faster, and we have polished the conveyor belt adhesive surface after brushing, a part of the glue to the conveyor belt inside infiltration, forming a rivet-like riveting point, this part of the gum solvent volatile than the surface of the volatile slower, In the high temperature drying environment is often the surface dry, and the solvent in the inside is not fully volatile, then in the joint, the inside of the solvent will be slowly volatile, a certain amount of time will be wetting bonding layer, damage bonding surface, affect the bonding effect.Conveyor Belt
     To eliminate the above impact, we need to be in the brush the first time, to ensure that enough to dry the timing or baking, to ensure that infiltration into the conveyor belt of the liquid solvent full volatilization, forming a stable adhesive layer. In the process of bonding conveyor belt joints, we sometimes follow the bonding process after all the process, but also found that the joint did not stick, peel off the joint, found that adhesive layer is not sticky, the surface of the adhesive is hard, shiny, this is "dry overdo" phenomenon.Conveyor Belt